NJ
AUTOMATIC INJECTION MOLDING is a notable inspection in the NJ category. This page provides verified data from US Department of Labor — OSHA Enforcement Data (v4 API) (2026), helping you compare AUTOMATIC INJECTION MOLDING against similar inspections and make data-driven decisions.
| activity nr | 11,288,172 |
| reporting id | 0213400 |
| estab name | AUTOMATIC INJECTION MOLDING |
| site address | 40 INDUSTRIAL RD |
| site city | Berkeley Hgts |
| site state | NJ |
| site zip | 07922 |
| owner type | N/A |
| owner type label | N/A |
| sic code | 3089 |
| naics code | 000000 |
| insp type | H |
| insp type label | Planned |
| insp scope | B |
| insp scope label | Partial |
| safety hlth | S |
| safety hlth label | Safety |
| union status | A |
| union status label | Union |
| nr in estab | 85 |
| open date | 1982-07-27 |
| close conf date | 1982-07-27 |
| close case date | 1982-08-30 |
| load dt | 2011-10-14 |
This OSHA inspection of AUTOMATIC INJECTION MOLDING in NJ opened on Jul 27, 1982 and closed after 1 months. The review was conducted as a programmed/planned review and focused on workplace safety conditions. Scope of the walk-around was partial. At the time of inspection, the establishment reported 85 employees on site.
The site of record for this inspection is listed below. Industry classification uses legacy SIC code 3089. Addresses reflect the establishment's location at the time of inspection.
In total, 5,149 OSHA inspections in NJ appear in this dataset. During 1982 alone, 240 inspections were recorded in the state — this inspection at AUTOMATIC INJECTION MOLDING is one of them. Enforcement volume varies year-over-year with OSHA staffing, federal priorities, and complaint inflow, so cross-year comparisons are most useful as a rough indicator of activity rather than a strict measure of risk.
This data helps you understand how AUTOMATIC INJECTION MOLDING compares to others in the NJ category. Use it to make informed decisions based on verified data from US Department of Labor — OSHA Enforcement Data (v4 API).
inspections with the closest data values to AUTOMATIC INJECTION MOLDING
The OSHAPeek editorial team aggregates and verifies inspections data from US Department of Labor — OSHA Enforcement Data (v4 API). Every statistic on this site is cross-referenced against the official source before publication, with quarterly re-verification cycles.
Read our full methodology or contact us with corrections.
Explore More Data Tools
For adjacent public-data tools, methodology notes, and network updates, visit DataPeek Facts.